the specs for the saw

7.5 hp 3 ph.

50/60 hz 380/440 v

3 speeds belt transmission

shaft final drive

 worm gear 50 to 1

air over hydraulic pump

max tralel speed 6mt min.

min travel speed 1cm min.

max cut depth 60 cm

max cut width 140cm

max angle 45degrees

blade rotates for longitudal cuts

max length of cut any matieral length

max angle rip cut 45 degrees.

blade 7.5mt long by 25mm

type of matieral to cut any up to 35 cm thick

med soft up to 60 cm thick

 

<!-- Start Bravenet Traffic Exchange -->
<SCRIPT LANGUAGE="javascript" TYPE="text/javascript"
src="http://exchange.bravenet.com/exit.php?id=3058143413">
</script>
<!-- End Bravenet Traffic Exchange -->

Shown tilted to one side

Shown straight up

Side  on view while tilted

rear view  note the centergy of the main pivot

The blade is over 20 feet long

to give the saw the deep cut depth I added a 3rd wheel

Now the blade is rotated  to cut traverse

rear view vertical

Hydraulic tilt cylinder

Drive shaft and gear box

Main drive wheel

Rotating guide roller mounting block

tilted the opposite direction

another tilt view

Shown here the carriage is locked in place with the blade rotated the saw can cut longitudally at an angle uses the same cylinders that causes the carriage to travel

Side view tilting.

Here you can see teh carriage lock

Now the lock is released

 Snown full cut depth andheight

 

Ok you are asking why the tires? the tires can be rotated down and locked in place so that the saw can be towed behind a vehicle to a job site.